Preform reheat lamp 1000W 230V

Sat, 20 Jun 2026 07:57:50 +0800

Out on the blow molding floor, a tired reheat lamp doesn’t just cost you speed. It shows up as uneven preform temperature, thick-walled spots, and too many rejects. When the heating tunnel can’t hold setpoint, the blow molder tries to chase stability by slowing the wheel or cranking power. Either way, you lose output. We built the 1000W 230V preform reheat lamp to deliver OEM-grade performance without the OEM price tag, so you can get back to stable cycles. What matters on the machine is matching energy and interface. This 1000W infrared emitter runs on 230V and draws the same load as standard OEM lamps, so your power circuits and controls don’t need changes. The quartz envelope gives you fast-response short-wave infrared, heating preforms quickly without surface overshoot. It uses an R7s connector and standard lamp lengths, so it drops straight into existing heating zones on Sidel, Krones, SIPA, Husky, SACMI, and Nissei ASB machines. And here’s why it works: consistent heat equals consistent stretch. With stable output, you can keep preforms in the intended temperature window, which cuts down crystallinity issues and keeps bottle weight in spec. That translates to fewer jams, less scrap, and more repeatable changeovers. The 1000W rating also covers the heat demand of thicker preforms and faster wheel speeds, so the lamp isn’t the bottleneck when you push the line closer to rated capacity. Before you install, verify the lamp holder and terminal block condition. Corroded contacts cause voltage drop and drive uneven heating. This emitter is a direct-fit replacement, but if your machine uses a different wattage or voltage, confirm compatibility with the heating controller and transformer. Keep the reflector clean and make sure airflow in the tunnel is proper. Infrared lamps run hot, and overheating shortens service life.

Reheat on Professional IR Heating Ware

Preform reheat lamp 1000W 230V