When your Husky HyCAP starts missing temperature setpoints, the whole line drags. Preforms come up short on heat, and you’re staring down blisters, thin walls, and scrap. The quick, right move is swapping in a heater lamp that matches the machine’s original spec. We build replacements to put the heat profile back where it belongs. What matters, technically We match the OEM infrared profile with short-wave halogen quartz emitters built for HyCAP duty. Each lamp is 2400 W at 230 V, with an R7s base and the correct arc length so it drops straight into the heating tunnel—no rewiring. Tungsten filaments and hard-sealed quartz tubes keep output stable over time, so preform heating stays repeatable from shoulder to finish line. We also hold the filament geometry tight to keep intensity even across the reflector, which keeps the heating band consistent. Why it works on your Husky HyCAP With the right lamp, you get the designed preform temperature spread back. Stretch blow molding can run at full cycle speed without chasing quality. That means fewer jams, less scrap, and bottle weight that holds steady. Energy use drops because the emitter comes up fast and holds setpoint, and the longer service life cuts downtime for lamp changes. In practice, we see stable output past 5,000 hours, so the heating tunnel stays predictable. Things to know Installation is plug-and-play, but the lamp is sensitive to oils and impact. Handle it with clean gloves, seat the R7s contacts firmly, and confirm the voltage matches the label. Reflectors age too. If they’re pitted or discolored, output will drift even with a new lamp. Plan a quick reflector check when you change bulbs.